- Sat Oct 02, 2010 8:27 am
#216409
So I am doing my build and would like some opinions.
Here is my build so far
B18A1
Leaving the head alone I think unless I consider a valvetrain package
Arp Headstuds
Arp Connecting Rod Bolts
Arp Flywheel Bolts
Arp Pressure Plate Bolts
Nippon Piston Rings
Hondata Map Sensor
Walbhoro Fuel Pump
650CC Injectors
Cometic HeadGasket
Gates Timing Belt
Ngk Plugs
Accel Wireset
Stage 3 Clutch
3 Inch Exhaust
T3/T4 turbo kit (14psi)
First I was wondering if I should do main bearing and rod bearings ? Second I was considering maybe doing rods and pistons ? Also if I use those injectors will they fit on the stock rail ?
Just curious as to what everyone's opinion is here
Here is my build so far
B18A1
Leaving the head alone I think unless I consider a valvetrain package
Arp Headstuds
Arp Connecting Rod Bolts
Arp Flywheel Bolts
Arp Pressure Plate Bolts
Nippon Piston Rings
Hondata Map Sensor
Walbhoro Fuel Pump
650CC Injectors
Cometic HeadGasket
Gates Timing Belt
Ngk Plugs
Accel Wireset
Stage 3 Clutch
3 Inch Exhaust
T3/T4 turbo kit (14psi)
First I was wondering if I should do main bearing and rod bearings ? Second I was considering maybe doing rods and pistons ? Also if I use those injectors will they fit on the stock rail ?
Just curious as to what everyone's opinion is here