General engine questions/issues that aren't specific to the other categories
By MarinePoolee
#139386 i have a 93 civic hatchback cx and was wandering what engines would fit it my car without much problem, and how much could i expect to spend for full swap?
User avatar
By teal_dx
#139394 D or B series are a direct swap. B's will require some additional parts (linkage, axles, mounts...) A swap could cost $1k to $3k depending on what engine you go with and who does the labor.

The best question to ask yourself is "how much power do I want" and "how much money do I have to spend"
By MarinePoolee
#139400
teal_dx wrote:D or B series are a direct swap. B's will require some additional parts (linkage, axles, mounts...) A swap could cost $1k to $3k depending on what engine you go with and who does the labor.

The best question to ask yourself is "how much power do I want" and "how much money do I have to spend"


I want enough power to beat the ricers on the streets that think they are in the fast and the furious, i dont have too much intentions on running at tracks, although it will be there sometimes.

And on the money factor its actually how much do i need to save.

And ive heard some bad things on the D series, any recommendations on B series? and where to buy?
User avatar
By Project_EG6
#139407 There's nothing wrong D series. A D16Z6 is pretty cheap and you can piece together a turbo setup for cheap and have decent amount of power. But you can get a B20b or Z and hooked up to a short geared tranny such as a B16A2 tranny or a GSR tranny, can truck along your hatch pretty good for an alright price.
By jdm jim
#139409 ls/vtec swap
User avatar
By chrono404
#139416
jdm jim wrote:ls/vtec swap

LS/VTEC's are not cheap to build properly. If you just throw a B16 head on a LS Block, you will have an LSVtec for about 3-6months until you have to Build a new bottom end. Even Then a LS With a B16 tranny will smoke a LSvtec with a LS Tranny. It will also be much more reliable.

I would Recommend a D16z6 swap with the D16z6(EX/Si) Tranny. It will give you all the power you need to daily drive around with. And in a Light weight CX and a little bit of Nitrous you will be taking people all day and night.

If you are afraid of nitrous and quite a few people are because of its misinformation then you can also go with a Turbo Setup. However A Turbo setup will wear out your engine much faster then a Nitrous setup as it will be making more power all the time, not just when you want to race. Much more money will be put into making a Turbo setup relaible.

My old Nitrous D16z6 beat H and K swapped EG's. I speak from experience. A Stock D16z6 w/ Intake, Headers and Exhaust(I/H/E), will be faster then a straight B18a/b(LS) swap. A B20 Swap with LS Transmission is just as slow. It will also loose to a d16z6 with i/h/e

If you are going to get a B Series swap, Getting a B18(LS) matched to a B16 Transmission will be quite fast. If you want VTEC(who doesn't) Going with a B16 or B18C(GSR) is the easiest way.Again You can make a B18a/b into an LS/Vtec, However doing so properly will cost more money then a Straight B16 swap.

IMO Going with a D16z6 will be your best bang for buck. Swaps normally got around 600-800 here. a Wet nitrous kit can be had for $300. Learn how to tune if yourself(Walk trough's in our Nitrous thread) You will be able to hang with B, H, and K Swapped Civics for between 900-1200 Bucks. If you do a stealth install(hide lines with wire loom, Hide solenoids) Then you will blow peoples minds that you just blew them out of the water in a D16z6. You also wont have a front mount intercooler attracting attention from thief's.
By MarinePoolee
#139420
chrono404 wrote:
jdm jim wrote:ls/vtec swap

LS/VTEC's are not cheap to build properly. If you just throw a B16 head on a LS Block, you will have an LSVtec for about 3-6months until you have to Build a new bottom end. Even Then a LS With a B16 tranny will smoke a LSvtec with a LS Tranny. It will also be much more reliable.

I would Recommend a D16z6 swap with the D16z6(EX/Si) Tranny. It will give you all the power you need to daily drive around with. And in a Light weight CX and a little bit of Nitrous you will be taking people all day and night.

If you are afraid of nitrous and quite a few people are because of its misinformation then you can also go with a Turbo Setup. However A Turbo setup will wear out your engine much faster then a Nitrous setup as it will be making more power all the time, not just when you want to race. Much more money will be put into making a Turbo setup relaible.

My old Nitrous D16z6 beat H and K swapped EG's. I speak from experience. A Stock D16z6 w/ Intake, Headers and Exhaust(I/H/E), will be faster then a straight B18a/b(LS) swap. A B20 Swap with LS Transmission is just as slow. It will also loose to a d16z6 with i/h/e

If you are going to get a B Series swap, Getting a B18(LS) matched to a B16 Transmission will be quite fast. If you want VTEC(who doesn't) Going with a B16 or B18C(GSR) is the easiest way.Again You can make a B18a/b into an LS/Vtec, However doing so properly will cost more money then a Straight B16 swap.

IMO Going with a D16z6 will be your best bang for buck. Swaps normally got around 600-800 here. a Wet nitrous kit can be had for $300. Learn how to tune if yourself(Walk trough's in our Nitrous thread) You will be able to hang with B, H, and K Swapped Civics for between 900-1200 Bucks. If you do a stealth install(hide lines with wire loom, Hide solenoids) Then you will blow peoples minds that you just blew them out of the water in a D16z6. You also wont have a front mount intercooler attracting attention from thief's.


If your not a salesman go be one :lol:

Cause you just sold me to the D16z6, now my question is where to find one?
User avatar
By Project_EG6
#139442 A D16Z6 is found in 92-95 Si hatchbacks, Ex coupe and sedans.
User avatar
By Ajax1989
#139456
MarinePoolee wrote:If your not a salesman go be one :lol:

Cause you just sold me to the D16z6, now my question is where to find one?


no shit, he should go work at honda or somethin.. :lol:
now im deff gettin a z6 :thumb: