- Thu Dec 16, 2010 6:42 pm
#228339
Anyone know what to do once you get the rear quarters from fixmyrust.com? how do i cut out the area perfectly and do i weld it and then sand it down and prime and paint? NEED HELP... step by step would be helpful if anyone has the time to do so
- Thu Dec 16, 2010 6:43 pm
#228340
sorry , wrong section.. meant to put it in my thread..
- Thu Dec 16, 2010 6:50 pm
#228342
This is a good section since it is about hatchbacks
What I did was hold up the panel on top of my current rear quarter and trace a line around the outer edge so I could see where to cut. Then I cut just inside of that line with the idea that it is always easier to take a little bit more metal off than to add some.
also check the thread in the exterior section called "fixing your honda rust"
What I did was hold up the panel on top of my current rear quarter and trace a line around the outer edge so I could see where to cut. Then I cut just inside of that line with the idea that it is always easier to take a little bit more metal off than to add some.
also check the thread in the exterior section called "fixing your honda rust"
Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage
- Thu Dec 16, 2010 6:52 pm
#228343
dont be shy to look in the diy section...
http://civic-eg.com/viewtopic.php?t=24
http://civic-eg.com/viewtopic.php?t=24