Civic-EG.com Forum 3.3.1

- Mon Sep 28, 2009 3:02 am #147743 Have you guys read that issue of project car with the hatch vs nissan g20? well I want to know the name of that tool that they use to roll the fenders. You should see that hatch it looks great.

- Mon Sep 28, 2009 3:08 am #147744 its an Eastwood fender roller, and they are $400-500

|95 Civic DX|03 Silverado 2500hd|97 Escort LX

[chrono404]

- Mon Sep 28, 2009 3:14 am #147745 You can also do it the ol skool ghetto way. l

You will need a jack, preferbally a floor jack, and a baseball bat, preferbally metal.

Use the floor jack to lift the car up enough so you can fit the bat inbewteen your tire and the bat. have the at a steep angle like 60-70 degrees, Then either work your way around with the bat around the tire or lower the car slightly and lift it back up and move over slightly.

This is what me and my friends have done to get rolled fenders. Works, and costs no money, Plus gives you something to do when hanging out.

Good luck

2017 Chevy BoltEV DD |2001 Honda CRV SE

- Mon Sep 28, 2009 3:51 am #147754 x2 on the bat method it works great once you get the agle down take your time and do it slowly and itll look just like the pros

[teal_dx]

- Mon Sep 28, 2009 3:36 pm #147851 I did the bat method when I was doing body work on my car:
http://civic-eg.com/viewtopic.php?t=31

here's a link to Tire Rack's tool for $259
http://www.tirerack.com/accessories/detail.jsp?ID=52

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage