- Sun Jul 25, 2010 9:02 pm
#206220
i just swapped a z6 into my 93 dx and i have a few questions.
the car i got the motor from was a automatic so i did the auto to manual p28 conversion.
i also took the ex harness, will that work with my car since its 5spd?
another thing is i now have 2 map sensors, 1 on the firewall and another on the tb.
-would i a)remove the pins from the passenger side clips(if so can anyone tell me what pins on what clip) -OR- b)or would running both of them just not make a difference (if the ex harness is even usable)
im somewhat new to engine bay wiring just never had this problem (always owned a ex eg)
so any help at all would be awsome thanks
the car i got the motor from was a automatic so i did the auto to manual p28 conversion.
i also took the ex harness, will that work with my car since its 5spd?
another thing is i now have 2 map sensors, 1 on the firewall and another on the tb.
-would i a)remove the pins from the passenger side clips(if so can anyone tell me what pins on what clip) -OR- b)or would running both of them just not make a difference (if the ex harness is even usable)
im somewhat new to engine bay wiring just never had this problem (always owned a ex eg)
so any help at all would be awsome thanks
