Indicators and brack lights stoped working.. help !!!!

ECU, Wiring, Sensors
 Reply
User avatar

Indicators and brack lights stoped working.. help !!!!

By TENGOKU25
- Tue Apr 13, 2010 2:43 pm #187397 so yer i not long ago installed sum diy white face dials on my project ej2 coupe and i just got round to geting sum petrol and geting sum power back in the battery so i could try them out but as i was haveing a check over i found the indicators and brack lights not working . there was not even the ticking sound when i put them on nore was the lights on the dash flashing but thay worked when i put the hazards on apart from only 1 of the indicator lights did not flash. i checked the indicator fuse and thats ok but i have not checked the brake light fuse yet but im shor its not thos fuses...could anuffer fuse have gone sum were when i jump started the car ?
User avatar

By teal_dx
- Tue Apr 13, 2010 5:57 pm #187430 I have never had a fuse blow when jumping the battery. But double check all your fuses. is it possible you may have left some wiring exposed when you had the dash apart, causing a short?
User avatar

By TENGOKU25
- Tue Apr 13, 2010 6:59 pm #187437 its all good naw all it needed was a nice wack to the lights and a little wigle to sum of the wires :D yay
User avatar

By egsedanguy
- Tue Apr 13, 2010 7:51 pm #187454
TENGOKU25 wrote:its all good naw all it needed was a nice wack to the lights and a little wigle to sum of the wires :D yay



dude thats no good. that means you got a bad wire somewere. hopfully its not exposed and start a dash fire... :o
User avatar

By TENGOKU25
- Tue Apr 13, 2010 8:01 pm #187457 oo crap never thort of that ill give it a good look over tomorow ... with my brake light i have to hit it sumtimes to get it working what do you think it is a loss wire or sum fing
User avatar

By egsedanguy
- Tue Apr 13, 2010 8:06 pm #187462
TENGOKU25 wrote:oo crap never thort of that ill give it a good look over tomorow ... with my brake light i have to hit it sumtimes to get it working what do you think it is a loss wire or sum fing


well it proly a lose ground somwere. do u have an aftermarket alarm in it? if so check all the splices were it wired into your harness and make sure its all good. also check for cut wires.
User avatar

By TENGOKU25
- Tue Apr 13, 2010 8:26 pm #187474 na its all standed. when i moved sum of the wires to try and get it i moved thos 2 that go in the back of the cluster
 Reply
Return to Chassis - Electrical