- Mon Jul 30, 2007 1:40 am
#17793
built-EGy8 wrote:Ive got my MAP all ready to be pinned but I have a little problem. There are 3 wires comming off of my MAP sensor. GRN/WHT,YLW/RED,andSolid WHT. which is pinned where in my harness?
Ok got it...
Green/White wire from the MAP sensor should change to Green/Blue after the main harness plug, and then goes to pin C11 on the P28
Yellow/Red wire from the MAP sensor should change to Yellow/Green after the main harness plug, and then goes to pin C10 on the P28
Solid White wire from the MAP sensor should change to Pink/White (93-95) or White (92) after the main harness plug, and then goes to pin C9 on the P28
Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo HatchMy Youtube Channel: 6th Gear Garage