- Thu Jul 09, 2009 2:50 am
#129431
here is my dent how hard will it be to weld in a new piece?
please help i dont like it i want it fixed
please help i dont like it i want it fixed
- Thu Jul 09, 2009 3:14 am
#129434
Thats not too bad...theres no need to cut or weld anything on that. Get the dent pulled or pushed out from the inside, a little pounding with a body hammer, and some filler and she would look good as new.
- Thu Jul 09, 2009 4:26 am
#129441
Yeah have you checked with a PDR guy? maybe they could get it our pretty close for you to bairly have to glaze it with some filler.. but if you do cut and weld it wouldnt be hard if you know how to weld. Tack welds only a few at a time so you dont get it to hot and warp shit. GL
- Fri Jul 10, 2009 5:37 am
#129631
not hard but not need.....just do like i said before use a panel beater or a stud gun to pull it you will have to shrink it a little after but its not hard... then put a thin layer of filler and sand it... it should be easy if yo know what you are doing
