Civic-EG.com Forum 3.3.1

- Sun Apr 13, 2008 10:13 pm #50399 So I just put a new exhaust cam in my b16 and I checked the adjustment of the valves they were good and set the timing now it wont start.
If one or more of the valves is bent will that keep it from starting?
I need help becuase i dont know what to do anymore i can hear the starter and see the cams turn when i turn the key but it wont turn over any help?? please?

THEY SAY I'M A BAD INFLUENCE I SAY THE WORLD IS ALREADY FUCKED I'M JUST ADDING TO IT

JASON WRYALS
93 del sol si
d15b2 single non v
soon d16a single v
or
ls/v not sure yet

[teal_dx]

- Sun Apr 13, 2008 10:54 pm #50409 bent valves will prevent pressure from building in that cylinder. no compression = no start. I'd do a quick compression test on each cylinder.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Tue Apr 15, 2008 4:52 am #50714

bent valves will prevent pressure from building in that cylinder. no compression = no start. I'd do a quick compression test on each cylinder.

Its going to be hard to do one without the motor running, needs to be at running temp to be accurate I would try to do a leak down on each cylinder

INLINEFOUR.COM

If you are in the Southern Ca. area, drop on by and visit our showroom.
11400 Knott Street, Garden Grove, CA 92841.
info@inlinefour.com Or Sales@inlinefour.com