okay lil stuck on the clutch release fork

General tranny info covering all models & motors.
 Reply

okay lil stuck on the clutch release fork

By DannyCraQ
- Sat Feb 16, 2008 7:51 pm #42534 okay ive got all the parts needed for my tranny now, clutch fork, spring, throw out bearing, new slave cylinder, anyone know exactly how this shit goes together? :thumb:

By DannyCraQ
- Sat Feb 16, 2008 7:57 pm #42535 ios the throw out bearing supposed to click onto the fork? i dont get how this is gonna work :?
User avatar

By teal_dx
- Sat Feb 16, 2008 8:39 pm #42542 http://www.hondaautomotiveparts.com/aut ... CH+RELEASE

http://www.hondaautomotiveparts.com/aut ... R+CYLINDER

here's a couple diagrams that may help, pics aren't very good though

By DannyCraQ
- Sat Feb 16, 2008 9:01 pm #42545 do i even have the right throw out bearing? cause judging by those diagrams and the manual i got it doesnt seem so

Image

:x

http://cgi.ebay.com/ebaymotors/ws/eBayI ... 87744&rd=1

i bought this one

By DannyCraQ
- Sat Feb 16, 2008 9:15 pm #42547 yea so i called up autozone and asked for my specific throw out bearing and ima go @ 4:30 to check it out, ima take mine and compare, if not, then im out 15 bucks on this one, but oh well. im sure i could re sell it. LOL :thumb:
User avatar

By chrono404
- Sat Feb 16, 2008 9:32 pm #42549 The throw out bearings little forks slide over the end of the shift fork. If I recall correctly there is dimples in the shift fork for the throw out bearing to ride in.

Page 12-12 of the 92-95 Civic Helms Manual.
Image

By DannyCraQ
- Sat Feb 16, 2008 9:33 pm #42550 oh and hey teal, on your radiator, what did u do to cap the auto tranny fluid lines?

By DannyCraQ
- Sat Feb 16, 2008 9:35 pm #42551
chrono404 wrote:The throw out bearings little forks slide over the end of the shift fork. If I recall correctly there is dimples in the shift fork for the throw out bearing to ride in.

Page 12-12 of the 92-95 Civic Helms Manual.
Image


yea i got that manual, i downloaded it off d-series.org

and its quite obvious i got the wrong bearing, so i threw this one up on craigslist or unless another member is interested in purchasing it.

15 bucks. lol never used ha

thanks tho chrono, ima go pick up my new bearing, this just set me back a couple hours :lol:

By DannyCraQ
- Sat Feb 16, 2008 9:58 pm #42554 oh okay, good shit, well starting @ 4:30, im going to be finishing this swap that ive been doing for over a month now HA

took some pics of my car in the garage

http://civic-eg.com/viewtopic.php?p=42553#42553


update :thumb:

By DannyCraQ
- Sat Feb 16, 2008 10:34 pm #42557 and for future refrence for anyone else

Image


the one on the left is the on ei got, thats for a cable series tranny, and the one on the right is one im getting for a Hydraulic Tranny.

dont make the same mistake i did!!!
 Reply
Return to Transmission