- Mon Feb 25, 2013 1:20 am
#327216
Ok so I am working on finishing up my auto to manual swap. I already had a manual 92 civic hb with a d15b vtec ( the car needed a lot of work). I acquired an auto 93 civic hb. I swapped everything over to the auto the motor, tranny, engine harness. when it came down to wiring the clutch switch i followed these instructions. http://honda-tech.com/showthread.php?t=2348557 . I went to start it up today and it started but still starts up without having to press the clutch. I haven't done anything to to the wires that connect to the auto shifter. I did swap the ignition from the manual car over to the auto one since my alarm was all wired up to it. Was there something I missed? I referenced this thread for the swap http://honda-tech.com/showthread.php?t=2090074. Any help would be greatly appreciated.
Connecting those 2 thick wires means your car can start any time. Connecting them up to the switch means it will only start when the clutch pedal switch is pressed.
Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage