- Thu Jun 22, 2017 1:15 am
#6906935
Hey everyone. To make a long story short in removing my turbo and going back to stock. I have the part around to swap back to stock,but my injectors are obd2
So far I have gathered the injectors can be used. I have to trim the clip part on the injector for the clip to fit.
Here's my confusion. The common yellow/black stripe wire from obd1 to obd2 is opposite of each other. On my eg the common yellow/black is on the left side if your looking at the front of th car,where as the obd2 common yellow/black is on the right.
So do trim my injector so my clip fits on as it should and call it a day, or do I have to repin each clip ????
So far I have gathered the injectors can be used. I have to trim the clip part on the injector for the clip to fit.
Here's my confusion. The common yellow/black stripe wire from obd1 to obd2 is opposite of each other. On my eg the common yellow/black is on the left side if your looking at the front of th car,where as the obd2 common yellow/black is on the right.
So do trim my injector so my clip fits on as it should and call it a day, or do I have to repin each clip ????