New members NEED to read the following:
'Rules & Guidelines' 'Using the Search Feature' 'Where should I post my Topic?' before posting on this forum!
By Eg3Gaz
#6907759 Hi there. I got interested Hondas from owning an EP3 Type R. Now I've sold the EP3 I've decided to build a budget track car. Being a big Honda fan growing up I've always wanted an EG. I've managed to get a rolling EG3 shell fairly cheap. In the pics attached you'll see my very slow progress so far. I've pretty much got it down to its bare shell. I need to replace the rear quarter, lower rocker and cut/weld in a plate behind the drivers seat. Rear quarter panel is on order, lower rocker ill make from sheet metal, same for floor patch plate. Engine wise I plan on looking for a d16 as I'm on a budget. Car will be fully stripped out and I plan on seam welding interior, engine bay etc. I've never had a project car before and I heard these are easy to build and a great car to start with/learn on. So here it is..... any tips would be appreciated.

Screen shot 2017-09-24 at 19.42.44.png

Screen shot 2017-09-24 at 20.05.29.png

Screen shot 2017-09-24 at 20.06.41.png

Screen shot 2017-09-24 at 20.10.19.png

Screen shot 2017-09-24 at 20.11.12.png

Screen shot 2017-09-24 at 20.12.00.png
Last edited by Eg3Gaz on Sun Sep 24, 2017 7:34 pm, edited 1 time in total.
User avatar
By teal_dx
#6907762 Welcome to the forum!
You're off to a good start with the metal repairs. I've never seen an EG with such bad rot in the floor area :shock: