Civic-EG.com Forum 3.3.1

- Wed Apr 16, 2008 9:54 pm #51144

well i picked up a good buy and it was a skunk2 " HALF " catback for 100..i only call it a half catback because im missing the piping in the middle of that picture and im also missing the gaskets and bolts..i was wondering if anyone could lend some help to see what i can get or to do to replace that piping and where to get some gaskets and bolts..

[teal_dx]

- Wed Apr 16, 2008 9:56 pm #51145 easiest & fastest thing would be go to a local exhaust shop. That's an easy piece to make.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Wed Apr 16, 2008 10:09 pm #51152 yeah, because it will be hard to find just middle, and for the bolts and gasket, i think autozone can cover u on that part.

"If I see it, Then i can, If it changes, Then i will adapt. If i make mistakes, then i will learn."

[teal_dx]

- Wed Apr 16, 2008 10:19 pm #51154 if you or you know someone who welds, you can order all the pieces from http://kteller.com they have mild or stainless and the resonators too.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Wed Apr 16, 2008 11:00 pm #51161

easiest & fastest thing would be go to a local exhaust shop. That's an easy piece to make.

- Thu Apr 17, 2008 1:29 am #51191 appreciate the help guys..FOOK YEA!

- Fri May 09, 2008 4:39 pm #54476 I just wanted to give you a quick heads up too. I have the same exhaust on my 92 Civic Si (except mine was complete). After you install the exhaust, you might notice that the two hangers on the actual canister portion may be a little long, and when you build up some heat and the exhaust system starts to vibrate back and forth, the hangers may start rattling against your rear bumper reinforcement. I cut about 1/4 inch off the ends of both hangers (after the bend of course) and now no more rattling. I tell you know cos it's easier to cut before you install onto the car. Granted this may NOT be the case for everyone, but it was the case for me and another friend of mine who also owns a 92 Civic Si. Hope that helps.

P.S. - You may also want to cut a little bit of that exhaust shield that covers your shifter fromt he exhaust. On hard right turns I'm starting to hear the exhaust rattling against that as well. It is, after all, a little thicker than the stock system.