Help with shock tower plugs!

ECU, Wiring, Sensors
 Reply

By Gunni
- Mon May 28, 2012 7:24 pm #306503 what make and model is the motor from ??
the problem is not the engine harness, its the firewall harness (incar harness or what u call it) any two peace harnesses have 99% same pinout as far u have same amount of plugs for example if u swap a b16 for a d16 in a eg u just plug the harness and off u go. u can also use obd2a-b harness in an eg with a "small" :eh: rewiring work . and also check the ecu plugs , u will have to use a p30 or chipped p28 for this and if u cant plug it in this harness u have now in youre car now u have to swap the harness anyway.

note .im in europe and this may be differant here.
be free to correct me if im wrong ... :roll:

By Gunni
- Mon May 28, 2012 7:45 pm #306508
EGCiviCKid wrote:i have found a d16z6 Engine Loom, Under Dash Interior Loom, Interior Fuse Box, Engine Fuse Box & Main Relay for sale

do i need all of it in my case or just the engine loom? :thumb:


after reading i found out so are u 8)

this would solve all youre problems.
User avatar

By EGCiviCKid
- Mon May 28, 2012 7:54 pm #306512 hi buddy thanks for the help :thumb:
i got an sir harness instead of the z6 do you know if it will do the same job and will i need to wire any additional sensors etc ?

By Gunni
- Mon May 28, 2012 8:59 pm #306520 interior (firewall ) harness ?? or complete harness ??

if so it should fix your problem
User avatar

By EGCiviCKid
- Tue Jul 10, 2012 4:56 pm #310537 Sorry to bring up old thread but... still stuck :cry:

my setup:
SIR interior/cabin harness
P28 chipped ecu
Obd2a B16a2 engine, with what i was told was the original engine harness..
however on closer inspection it didnt have the part which extends into the cabin.. and i believe all obd2a harnesses do this.. so it cant be one!
I think its an itr harness of some sort?.. as most look the same.

Please can someone help me identify this harness! .. ignore the red circles

Image
 Reply
Return to Chassis - Electrical