- Mon Apr 11, 2016 3:54 pm
#358868
Came out great. Lets see some video of her running on that bottle!
- Thu Apr 28, 2016 12:16 am
#359004
Thanks guys!
No, I did not paint it myself. A buddy did it for me. I helped where I could, but he did all the spraying.
I do have the nitrous installed and ready to go, but I have been side tracked with another project (see below). I just need to install my new exhaust, fill the bottle and have vit retune/tune on nitrous. Of course I will be putting my Deatschwerks 1000cc fuel injectors in when I get there
I hope these updates will get ya'll up to speed on my never ending, but slow, build.
Bottle mounted and plumbed
Solenoid installed and plumbed and wired to ecu (Kpro). Going dry shot, so the fuel solenoid not plumbed.
Arming switch installed and wired to ecu (Kpro).
Deatschwerks 1000cc injectors
And now for the project that has been keeping me busy and not getting my new 3" exhaust and nitrous completed. K24a4 block, 88mm bore, Wiseco forged 12.5:1 pistons, Manley forged H beam rods, ACL bearings, new PORTED Type S oil pump and windage tray, new oil pump chain + guide, new timing chain and timing chain guides, new timing chain tensioner, and lower HPT timing chain guide.
My engine stand is occupied so I've been working on my floor in my room as seen in the last few pics lol. Which is actually for the best because my shed is damp and cold. Much better indoors where is warm and safe lol. Do whatcha gotta do!
Until next time!