Civic-EG.com Forum 3.3.1

- Wed Oct 15, 2008 5:28 am #74383 is minime wright up have the same ecu pinout for a bseries obd1? and i tried it and didnt work. obd1 gsr into a 4dr dx. anyone?

supercharged and turboed vtec bottle of NOS for your ITBs!

- Wed Oct 15, 2008 3:16 pm #74403

is minime wright up have the same ecu pinout for a bseries obd1? and i tried it and didnt work. obd1 gsr into a 4dr dx. anyone?

You need to wire up
1)VTEC Solenoid
2)VTEC Oil Pressure (These two if the motor did not have a VTEC motor previously)

and...

3)Knock Sensor
4)IAB's

- Wed Oct 15, 2008 4:20 pm #74412 what happens if i dont wire the iab and the knoc sensor? im getting a skunk2 intakemani, i dont like the iab. and where are the iab and the sensor wires start. arent they vacuum? is minime and a bseries swap with vtec the have the same ecu pinout?

supercharged and turboed vtec bottle of NOS for your ITBs!

- Wed Oct 15, 2008 8:02 pm #74444

what happens if i dont wire the iab and the knoc sensor? im getting a skunk2 intakemani, i dont like the iab. and where are the iab and the sensor wires start. arent they vacuum? is minime and a bseries swap with vtec the have the same ecu pinout?

Well if your getting a Skunk2 intake mani then you won't need the IAB so you can scrap that. Click on the link below for wiring and etc.

http://www.c-speedracing.com/howto/b18cswap/swap.php


Regarding the pinouts, all depends on what ECU you will be using, if it's an OBD1 ecu you'll find the pinout diagrams on the link below

http://technet.ff-squad.com/wiring.obd1.htm

Try using google dude, there's massive resources on what your trying to do, HT is one massive directory which will answer the questions you have, it's a good learning curve for you too.

all the best

- Wed Oct 15, 2008 9:10 pm #74459 thankx dude

supercharged and turboed vtec bottle of NOS for your ITBs!