- Thu Mar 07, 2013 11:02 pm
#328024
So, i did a extremely mild wire tuck. Just the headlight harness on both sides and the wiper motor wires. Now all of a sudden I am geting no power to the inside of my hatch. I just did all my suspension work and clutch. I put the battery in about 2 hours ago and went to turn the key and nothing happened. No lights on the dash, no dome light, I tried to turn my headlights on and honk the horn and nothing. So far i have checked:
All terminals on both sides of the fuses in the under hood fuse box, all are getting power.
Brand new battery
Checked the valve cover, tranny, battery, and water neck ground all are good and tight.
Checked all connectors at the dashboard fuse box, all are plugged in.
I opened the ECU, i didnt see anything burnt and it didnt smell like there wa either.
I did seperate the connectors for the under hood fuse box and re-loom them seperately. This might be the issue but i have no idea. Like i said, power is getting from the battery, to the under hood fuse box and then it seems like it stops. When i turn the key absolutely nothing happends. Does anyone have any ideas on where i should start?
Also does anyone have a diagram or a picture on the connectors for the under hood fuse box? This way i can check and make sure i put the correct wires into the correct pins.
All terminals on both sides of the fuses in the under hood fuse box, all are getting power.
Brand new battery
Checked the valve cover, tranny, battery, and water neck ground all are good and tight.
Checked all connectors at the dashboard fuse box, all are plugged in.
I opened the ECU, i didnt see anything burnt and it didnt smell like there wa either.
I did seperate the connectors for the under hood fuse box and re-loom them seperately. This might be the issue but i have no idea. Like i said, power is getting from the battery, to the under hood fuse box and then it seems like it stops. When i turn the key absolutely nothing happends. Does anyone have any ideas on where i should start?
Also does anyone have a diagram or a picture on the connectors for the under hood fuse box? This way i can check and make sure i put the correct wires into the correct pins.
Last edited by rustyrex on Sat Mar 09, 2013 12:42 am, edited 3 times in total.