- Sun Jun 10, 2012 4:22 pm
#307855
I have lurking in this forum for a while.
Just want to share some stuff on my DD.
When I got my EG6 in 2010
One of the first thing I did was to tidy up the wirings under the dash
It came with the EG9 seats
Replaced with EG6 seats ;)
Replacing aftermarket hand brake handle with EK9 hand brake handle
Cleaning up the JDM clusters with plastic polish
Got my NARDI
The RPM readings were out, so I did a little recalibration by adjusting the potentiometer at the back. (NO REMOVAL OF NEEDLES!!)
For how to do it refer to this: http://honda-eg6.blogspot.sg/2010/10/rpm-meter-calibration-how-to.html
Got the PLX SM-AFR ver 1 with DM-5 which helps in monitoring the health of the engine.
Replaced the EG throttle cable with the EK throttle cable for a slightly cleaner look
Skunk2 Chamber kits front and rear
Skunk2 LCA
If I knew about Function 7 earlier, I would have got those instead..
Relocated the battery to the boot. I had a bracket fabricated to install two of the PC680. So that I can have them lie flat and still use the boot tray.
Replacing the rear ARB bushing
That's it for 2010
Just want to share some stuff on my DD.
When I got my EG6 in 2010
One of the first thing I did was to tidy up the wirings under the dash
It came with the EG9 seats
Replaced with EG6 seats ;)
Replacing aftermarket hand brake handle with EK9 hand brake handle
Cleaning up the JDM clusters with plastic polish
Got my NARDI
The RPM readings were out, so I did a little recalibration by adjusting the potentiometer at the back. (NO REMOVAL OF NEEDLES!!)
For how to do it refer to this: http://honda-eg6.blogspot.sg/2010/10/rpm-meter-calibration-how-to.html
Got the PLX SM-AFR ver 1 with DM-5 which helps in monitoring the health of the engine.
Replaced the EG throttle cable with the EK throttle cable for a slightly cleaner look
Skunk2 Chamber kits front and rear
Skunk2 LCA
If I knew about Function 7 earlier, I would have got those instead..
Relocated the battery to the boot. I had a bracket fabricated to install two of the PC680. So that I can have them lie flat and still use the boot tray.
Replacing the rear ARB bushing
That's it for 2010