where can i find ctr or itr pistons

B16, B18, B20
 Reply
User avatar

By forcefedEG
- Thu Apr 29, 2010 5:55 pm #190950 hope this helps :thumb: 8)

http://www.fjdistributors.com <- look under all motor or naturally aspriated

http://hmotorsonline.com/shop/sc2000sea ... ne%20Parts <- few pages to sift threw
User avatar

By eghatch21
- Fri Apr 30, 2010 12:05 am #191062 thanks guys ill look at it all cuz i wanna do a poormans type r
User avatar

By eghatch21
- Fri Apr 30, 2010 1:44 am #191073 so these r the pistons i should use then
User avatar

By forcefedEG
- Fri Apr 30, 2010 12:52 pm #191111 the ctr pistons will put your compression up there pretty good, a poor mans R will run great, i love mine and its still all stock gsr stuff in the bottom end... before you buy pistons you just need to figure out exactly what you want to do and what your goals are, you cant blindly buy parts for a build your not 100% sure on your goal :thumb:
User avatar

By eghatch21
- Sun May 02, 2010 9:03 pm #191487 yea thats true i think i would wanna either go completely stock or a stock bottom end wit a built head
User avatar

By forcefedEG
- Mon May 03, 2010 12:36 pm #191577 i would recomend either the jdm or usdm itr pistons then.... :thumb: they wont give you too much compression...
User avatar

By eghatch21
- Mon May 03, 2010 11:48 pm #191678 ok kool im still figuring out wat im gonna do but is urs completely stock
User avatar

By forcefedEG
- Tue May 04, 2010 12:43 pm #191746 yes sir, mine is a bone stock usdm gsr bottom end 95 spec, with a 2000 si head, mild port job, i had the valves re-surfaced, i used the gsr cams, and arp head studs, and everything else is stock, intake manifold, throttle body, injectors, everythings stock... when i had that engine in the car i have the turbo on now, i had that enigne, with a dc ITR replica header ande a stg 2 clutch and a gsr trans, it ran very good and pulled very hard, i out ran a dyno tuned z6 on like 9psi, i also had my chipped p28 behind it then,

now i have it in my dd with a stock clutch, LS grears and a gsr ecu and a 4to2to1 header.... but it still runs great...
User avatar

By eghatch21
- Tue May 04, 2010 9:25 pm #191845 hell yea i wouldnt wanna go turbo yet i will wait a while before that
User avatar

By forcefedEG
- Wed May 05, 2010 12:37 pm #191942 a friend of mine has a turbo poormans r in his crx, and it runs really good, i never turbo'd mine tho, i decided to turbo a b16 instea lol... my poormans is getting miles on it now, so id like to freshin it up an maybe do a high compression kit... but all in all a poormans r is a solid setup imo
User avatar

By eghatch21
- Sat May 08, 2010 2:59 am #192490 thats wat i keep hearing and thats y i wanna do it
 Reply
Return to B Series