- Wed Oct 24, 2012 11:22 pm
#318594
I'm planning on building a spare ls I have. When I got the motor it came with a set of ctr pistons. My buddy just built a ls using ctr pistons and it runs great.
my question is why exactly is milling the rods or piston required? My friend didn't ask the Guy machining them to do any milling so unless he discovered it himself they weren't milled any.
so is it required or just recommended?
Thanks for any positive input. I really wanna use b16 p30 pistons but idk if my funds will allow at the time.
my question is why exactly is milling the rods or piston required? My friend didn't ask the Guy machining them to do any milling so unless he discovered it himself they weren't milled any.
so is it required or just recommended?
Thanks for any positive input. I really wanna use b16 p30 pistons but idk if my funds will allow at the time.