B16, B18, B20
User avatar
By elrompetoto
#169584 I just picked up a b18b1 from a freind with an auto tranny I have a b manul tranny also but its cable
1 can I use the the auto cv joints aka half shaft 2

2 can some one give me a web site where I can find b shift link

3 can I use my stock mounts or do I have 2 buy ls integra ounes
User avatar
By JUICE
#169609 the auto axles wont work with the manual tranny, not sure off hand where to get the linkage try local forums and CL, and you'll have to get B series mounts

:thumb:
User avatar
By That One Dude
#169624 I'm reasonably certain you can't use the auto axles with the manual tranny. Something about the length. Lemme check right quick.

EDIT: I was wrong. The part numbers from the Auto and Manual axles are the same for the B18B1.

Manual: http://www.hondapartsunlimited.com/inde ... ersion=3DR GS (LEATHER)&transmission=KA5MT&section=LIST ALL&components=DRIVESHAFT (1)&submit=submit

Automatic: http://www.hondapartsunlimited.com/inde ... ersion=3DR GS (LEATHER)&transmission=KA4AT&section=LIST ALL&components=DRIVESHAFT (1)&submit=submit
User avatar
By elrompetoto
#169634 thank u so much guysssssssssssss damn i love this site no home
User avatar
By chrono404
#169708 x2

Manual and Automatic Half shafts are the same for both sides on B Series, The Center/Intermediate Shaft is different between the two transmissions. Auto sticks back farther then manual.
User avatar
By elrompetoto
#169885
chrono404 wrote:x2

Manual and Automatic Half shafts are the same for both sides on B Series, The Center/Intermediate Shaft is different between the two transmissions. Auto sticks back farther then manual.
soi have 2 change thehalf shaft ?
User avatar
By Classiccarsrule85
#169893 no auto and manual are the same its the intermidiate shaft that is different.