Civic-EG.com Forum 3.3.1

- Sat Jul 04, 2009 8:37 pm #128337 OK, so my vtec wasn't popping so I switched out the solenoid gasket that had the big screen and this other lil screen and replaced it. Vtec was working after i replaced those but about one day ago it just stopped again? What should I check now? I still need to replace my cam seal and distributor o-ring. thanks

- Sun Jul 05, 2009 7:40 pm #128459 anyone

- Sun Jul 05, 2009 10:03 pm #128471 any leaks around that area?.... any CEL? Vtec wont kick on when the oil pressure is low.

92 civic cx sold!!
horizon gray 94 LX-A wrecked :/
white 92 civic Si (traded)
primered 94 teg sold
92 civic DX sold!!
93 red EX coupe parted out!
93 LS400 Midnight indigo sold!
92 civic LX sold!!
90 240sx sold!
93 faded black EX coupe

- Mon Jul 06, 2009 12:51 am #128495 make sure you have plenty of oil.
what oil pan do you have?

D16z6. Golden Eagle. AFI Turbo. Precision Turbo. Hondata. CG racing.
618hp, 407tq SOHC 10.68@137
My 92 hatch SOHC build. Quest for +600hp. Check it!

- Mon Jul 06, 2009 1:38 am #128511 check the oil pressure replace the cam seal and the o-ring
then check and make sure the parts you just put on havent flawed already ( it happens ) and may wanna even change the oil if it does have the pressure it needs hope this helps alittle