Civic-EG.com Forum 3.3.1

- Sun Apr 12, 2015 4:21 am #353107 I just bought a skunk2 pro series intake manifold from a friend tonight (4/11/15) however it didn't have the throttle body, my question is has anyone here used this intake manifold with a oem throttle body? If so it'll only be until I save up and buy a matching skunk2 throttle body.


Thanks for any and all input

Its not about the name of the parts you use its the fact your making the attempt to make it your own

- Sun Apr 12, 2015 10:58 am #353108 Any D/B series throttle body OEM of aftermarket will fit that manifold. The only thing you have to be careful of is using a throttle body with a bore bigger than the bore of the manifold.

Instagram
https://instagram.com/enjoymotorsports

https://enjoymotorsports.com

- Sun Apr 12, 2015 1:38 pm #353110 Ok thank you

Its not about the name of the parts you use its the fact your making the attempt to make it your own

- Sun Apr 12, 2015 4:29 pm #353112 the manifold can be ported. if you do get a larger tb than the manifold then you can gasket match the manifold so it will flow correctly

your car is your story, dont let someone else write the book.

91 s10 (sold)
92 civic si with jdm b16a (Sold) http://civic-eg.com/viewtopic.php?t=13460
99 civic lx (current) viewtopic.php?f=63&t=30348

- Sun Apr 12, 2015 9:27 pm #353115 I knew it could be ported. I just read on skunk2 's website that the oem throttle body couldn't be used but also read it could on other sites and was confused.

I'm only planning on a 66-68 mm throttle body so shouldn't be to big for it

Its not about the name of the parts you use its the fact your making the attempt to make it your own