- Wed Mar 10, 2010 12:38 pm
#180360
well first i tested the light to see if it was good and it was.
then i would trace the circuit back to the pin out connectors.
somewhere on the main board the power was not getting to the light
so i just jumped it and went from the illumination pin on the back right to the front circuit board with the buttons and leds.
then i would trace the circuit back to the pin out connectors.
somewhere on the main board the power was not getting to the light
so i just jumped it and went from the illumination pin on the back right to the front circuit board with the buttons and leds.