Civic-EG.com Forum 3.3.1

- Wed Oct 08, 2008 4:54 pm #73328 ok i have a set of corbu harnesses that im going to install in my eg sedan. i just dont know what to do bout the shoulder straps. what do i need to mount them. rally bar, drill holes ??? so what do i need to do???

- Wed Oct 08, 2008 7:12 pm #73344 well you will need a semi cage probaly a rally style something that will go right behind almost 90 degree the belt but you must do some research because im not totally sure on the angle or position all i know is...

If you place the back straps to the seat bracket area where they bolt in or on the floor in the event of a roll over you risk compressing your spine...

1980 volvo 242
2001 crv
not using punctuation or good sentence structure since day 1

- Wed Oct 08, 2008 8:38 pm #73358 ok well then. i still dont know what to look for. is it possible to build somthing and weld in or is there some place to search for a roll bar/rally bar.

- Wed Oct 08, 2008 11:00 pm #73390 i know a few companies make roll cages but you could make something and weld it in as long as your good at welding since this is a life line type thing.....

but if you are building a cage or a partial it may be some work but you may want to make it a bolt in rather than perm weld....

Just make sure you use the correct size steel tube....

another option would be to buy a universal cage and adapt it to your application....

cusco makes something like this i think

id suggest unless you plan on going all out racing soon a 4pnt cage will do you well but it only gets safer and stiffer as you go up

I typed into google and yahoo and came up with alot of info on cages but your best bet would be somewhere like scca or other racing sites

1980 volvo 242
2001 crv
not using punctuation or good sentence structure since day 1

- Thu Oct 09, 2008 12:20 am #73403 well i work at a bodyshop so i have all the tools and ppl to help build one. and yes i will be going to track with it i hope. building my engine for turbo. so i will be putting lots into the hp factor. im not into full cages as i dout ill need it. but the 4 point cages are more sutible sine i will be on the street much more. and i dont wanna weld it in, since i might not have the car for ever. but a bolt in sounds nice. what bout a diagram of the bends and wellds??? or do i have to fab a disigne my self??? and what grade of metal do i use and the diamiter???? is the tube cheap to get in like 8ft pcs??? and is the metal tig weldid??? any more info would be nice....thanks for the help so far..

- Sun Oct 12, 2008 1:32 am #73847 hey, i dunno if youve seen the harness bars they make... they mount to the B pillar behind your headrest i believe, but r available in universal and fitted models so idk. they look nice, and if u can weld, u could definetly take care of this. search harness bar(s) on ebay. hope this helps u out somehow, good luck.