- Wed Nov 11, 2009 8:43 am
#155981
i picked up a EG6 and these are the mods, B18a1 block bore .40 over, oversize ctr pistons, acl bearings, micro polish crank,ctr crank pulley, p72 head,p72 headbolts,proffesional intake manifold,68mm TB, virgin p72 ecu............................. what i have been reading is this set up is very bad news. too much compression?
please give me some input on this, car runs good, little bit of white smoke on starup and if i rev it hard. i have a stock GSR motor sitting, is it jus worth droppin that in? thanks guys
please give me some input on this, car runs good, little bit of white smoke on starup and if i rev it hard. i have a stock GSR motor sitting, is it jus worth droppin that in? thanks guys