Civic-EG.com Forum 3.3.1

- Mon Feb 22, 2010 2:37 am #176886 Hey guys, I'm Ethan and just got a 94 ex as my first car. 5spd, d16z6, all stock except the valve cover gasket Looking forward to this forum as it is the best I've found so far. By the way, I was reading a DIY article by chrono404 on transmission bearing replacements since my input shaft bearing is shot. . . He didn't include how to take out the transmission since there are DIY articles on that and that makes sense, but I can't find any on this site. Am I just a noob and overlooking something, or is he refering to another site? Anything's possible.

- Mon Feb 22, 2010 2:50 am #176887 there on the main page, just scroll down, its in the center ya cant miss it

[chrono404]

- Mon Feb 22, 2010 3:01 am #176890 Jack the car up, Take suspension apart, pop axles out of the transmission, support engine, remove starter, and unhook reverse wires, undo linkage and bitch pin, then unbolt transmission, pull it separate from the engine, then lower it out of the car, I normally pull the transmission out of the engine, then slid it on my chest, then slide it on to some cardboard and pull it out from under the car.

Need more details? pick up a 92-95 civic helms manual and it will show you pics of what to do.

More recently i have gotten lazy and just pull engine/tranny out in one peice, work on tranny then put it back on or put in a replacement and drop it in one peace.

there on the main page, just scroll down, its in the center ya cant miss it

Its also under the MISC pulldown on the top of every civic-eg page.

2017 Chevy BoltEV DD |2001 Honda CRV SE

- Mon Feb 22, 2010 4:14 am #176909 Thanks guys, must have missed all that.

- Fri Feb 26, 2010 9:23 pm #178039 Welcome to the site

CALL TOLL FREE 866-403-3393

- Fri Feb 26, 2010 10:47 pm #178060 welcome to the site.

1992 EG8

- Sat Feb 27, 2010 12:38 am #178084 Welcome to civic.EG

- Sat Feb 27, 2010 6:22 am #178130 welcome enjoy the stay