- Wed Jan 11, 2012 7:21 am
#289424
They need some centre caps and a wash but yeah they work well similar to a set I had on my old 1.3 hatch
- Wed Jan 11, 2012 7:28 am
#289428
Yeah I'm thinking about powder coating them bronze or white but there 14's to idk what I wanna do
- Wed Jan 11, 2012 3:27 pm
#289463
185/65/14
- Thu Jan 12, 2012 6:20 am
#289634
Come on peps let me know what you think
- Thu Jan 12, 2012 3:23 pm
#289654
They look nice,
- Thu Jan 12, 2012 6:04 pm
#289671
They don't look to small ???
- Thu Jan 12, 2012 6:04 pm
#289672
They don't look to small to you guys
- Thu Jan 12, 2012 6:26 pm
#289675
they look fine your car just looks waaayy to high..
James,
My vtec is better than your vtec.
'95 hatch
My vtec is better than your vtec.
'95 hatch
- Thu Jan 12, 2012 7:05 pm
#289678
Yea especialy the rear.
These are gs integra wheels on my winter beater. They are 14's i think those wheels look like a good fit on your car.
egcivicboy wrote:they look fine your car just looks waaayy to high..
Yea especialy the rear.
These are gs integra wheels on my winter beater. They are 14's i think those wheels look like a good fit on your car.
- Thu Jan 12, 2012 8:56 pm
#289692
they look fine. polish them up and run them.
and lower the rear.
and spell check/grammar is a wonderful thing. try it sometime!
and if people want to leave a response, they will.. no need to keep bumping an opinion thread.
and lower the rear.
and spell check/grammar is a wonderful thing. try it sometime!
and if people want to leave a response, they will.. no need to keep bumping an opinion thread.
2007 Honda Civic Si
- Fri Jan 13, 2012 6:57 am
#289761
The sad part is that I'm on lowering springs and the car still site that high....do you guys think the rims would look good in white.I'm thinking about spraing them
- Fri Jan 13, 2012 1:26 pm
#289799
get them powder coated. the finish will be so much better
lunaticracer21 wrote:The sad part is that I'm on lowering springs and the car still site that high....do you guys think the rims would look good in white.I'm thinking about spraing them
get them powder coated. the finish will be so much better