Civic-EG.com Forum 3.3.1

- Thu Aug 12, 2010 4:54 am #208565 Can you use a stock d16z6 wiring harness for a obd2 gsr motor??? Or could you use the gsr obd2 wiring harness and hook it up to a 94 civic ex with no prob???

- Fri Aug 13, 2010 5:30 am #208786 youll have to extend some wires but you could use the obd1 harness if your useing the obd1 dizzy

1980 volvo 242
2001 crv
not using punctuation or good sentence structure since day 1

[chrono404]

- Fri Aug 13, 2010 6:07 am #208788

youll have to extend some wires but you could use the obd1 harness if your useing the obd1 dizzy

x2

Reuse your z6 wiring harness. You will have to run wires for your knock sensor(or disable it with tuning) and extend the o2 Wiring from front to back.

You will need a OBD1 B16 or B18c GSR Dizzy. You can take the obd1 electronics from your z6 dizzy and put them in the obd2 b18c dizzy. The Electronics swap over with no issues as long as you keep the same center shaft(sohc vs dohc). If your going to buy a new one 94-95 Delsol VTEC Models came with USDM b16's as well as the 94-95 Integra GSR has the dizzy you want if your going to buy one from an Autozone styled store.

2017 Chevy BoltEV DD |2001 Honda CRV SE