Page 1 of 5

Weight Reduction

PostPosted: Thu Sep 28, 2006 6:53 pm
by teal_dx
Unless you're serious enough about performance to give up luxury, you might not want to try this. My car is not going to be a daily driver any more, so why not shed some lbs.

The great thing about these cars is their weight. That's why a torqueless 4cyl can keep up with a 225hp v8, because the v8 is in a 3600+ lb vehicle. It's all about the power to weight ratio. Every new generation of the civic has been getting larger and heavier than the previous. (Their engines have also been getting more powerful to compensate for this- look at how well the K series does in a EG)

It is said that every 100 lbs you shed will take .10 off of your 1/4 mi time.

Every pound counts if you are serious. Also the best place to start is unsprung weight (wheels & suspension).

First get some lighter wheels. Large wheels will slow you down, even if you have lightweight 17" rims, as they spin the rotational mass will increase. (think about holding a bucket of water by the handle and spinning it in a circle. Rotational Mass keeps the water in the bottom of the bucket). 15" wheels is really the largest these cars need in terms of performance. A 15" rim will get you options of a 6.5" or 7" width. Depending on how much you want to spend will determine on how light you can go. Racing Hart CP035 15x6 weighs in at 7.9 lb, very light. A 15x7 at just under 10 lb. Still very light. Under 10 lbs for a 15" wheel is great. Forging is the manufacturing process that makes wheels stronger, and therefore lighter so less material is needed. Rota makes a copy of the expensive RH CP035, the Rota Sub-Zero. It is cast, not forged, and a 15x6.5 weighs 12.9 lb. and also cost much less. You get what you pay for, a knockoff rim will always cost less but weigh more. The popular Rota Slipstreams weigh 11.9 for a 15x6.5" which is still a bargian for the cost, making them such a popular choice.

There's the same wheel weight list floating all over the web. I'm not sure who to credit for creating it but they did a great job.

http://forum.midwestscions.com/showthread.php?p=480

So being on a budget, I decided to use the 14" rims from my 96 HX. The HX boasts great miles per gallon and light rims from the factory helped to achieve that. They weigh 11.75 lb each. The VX was the EG version of the HX, also claiming great gas mileage. They came with 13" rims that weighed 9.something lbs each.

Image
The 14" HX rims

Next I removed my entire interior (partially because of other work I would be doing to the car)


I went a step further and removed all the sound deadening applied from the factory. My hatch is a DX, the CX has the least amount of deadening.

Image
The easy way to do this is use cold rather than heat. A heat gun will work, but make a sticky mess. I did this in 4? F weather using a mallet and gasket scraper. The tar sheet was frozen solid and shattered off in chunks.

Image
(The SRS unit, sensors, and wiring have all been removed in the second pic)

Image
I have yet to weigh, but I would guess about 10 lbs.

Image

Image

Here's what I have removed:

Pulled front & rear seats, carpet, seatbelts, headliner, door panels, rear plastic panels, inside of tail gate, rear washer motor, heater core, blower motor, air controls, SRS sensors, module & harness, sound deadening, spare, jack, and some big stamped steel bracket that was under the dash.

Going to put the front seats & belts back in. Also the dash, radio & door speakers. (I gotta have music untill I can listen to a HKS blowoff )


From the engine I deleted power steering lines & fluid tank, washer fluid tank & lines, charcoal canister, and got a lighter battery. I never had A/C, also thinking about pulling the wiper motor and wipers, but I'd be in trouble if I got caught in a storm. I guess there is Rain-X.... we'll see. Also I am converting from Auto to Manual which is supposed to be a little bit lighter.

Image
Here's my battery... $25 at the autoparts store. Optima & NRG are nice because they are sealed and you can mount them anywhere, even inside the car. But I can't spend that much, so here is my poor man's Optima. It weighs about 15 lb less than stock and is much smaller. Also in the pic is the Tray I started to build that will mount the battery inside the bumper.

This car was about 2200 lbs stock, I'm aiming to get it around 2000 lbs. In addition to faster accelleration, less weight will decrease your braking distance and improve handling. Weight reduction is always a good thing!

PostPosted: Sun Oct 01, 2006 9:38 pm
by Boosted_cx
holly crap you like got rid of everything!!! i was only thinkn bout gettn rid of my back seat and what not...you went all out lol and did i see a bov there??? are you boosted???

PostPosted: Tue Oct 03, 2006 4:24 pm
by fresh eh2*
yea i was thinkin bout takin out tha bak seat too but this dude juss took it to anotha level lol

PostPosted: Fri Oct 13, 2006 6:09 am
by eghatch
yeah i have taken out my back seats, seat belts,rear panels.. everything you are doing pretty much.. left the sterio and speakers

PostPosted: Sat Oct 14, 2006 3:23 am
by 1993 Civic Si
Great ideas!

I also plan to go with the HX wheels after next season. Right now, I autox in stock and I believe the HX's are 5.5" wide, as opposed to my Si's 14x5's. When/if we step up to STS, we'll prolly be going with the HX's.

I did switch to 1st Gen CRX Si alloys and saved a little weight over my stock steelies!

Most of the interior stuff I can't remove.

On a tangent, one thing I do that's counter-intuitive to all this is the amount of fuel I run at events. I run between 3/4 to a slam full fuel tank.

Why? I can't take the credit for this. A local hotshoe tried this as my co-driver one event and it WORKED. By adding fuel (as opposed to the 1/4 tank or less I was running), the weight actually helped balance the car and made it rotate GREAT. It rotates so well, it almost feels like a RWD car. I almost expect throttle oversteer!!!

Anyway, great ideas! I can use some of them in STS!!!

PS...can't see the pics!!

PostPosted: Sun Oct 15, 2006 5:54 pm
by solbrothers
yeah i gutted my 1989 escort gt... it started at 2300lbs with me in it. i removed all of the interior panels, sound deadening, door panels, seats, entire dash, spare tire and jack, i also picked up some semi-rare Merkur xr4ti wheels, the car came from the factory as a ps and ac delete, also it had manual windows. and finally i replaced the rear side windows with lexan. when i was done the car weighed 1900 lbs with me in it!! and i weigh 160 lbs!! but i would not reccomend doing this to a dd car...

PostPosted: Mon Oct 16, 2006 12:22 am
by 1993 Civic Si
Check this for the ultimate in weight reduction...

http://crazyjim.ramelot.com/14seconds.htm

8)

PostPosted: Wed Oct 18, 2006 3:11 am
by solbrothers
that is nucking futs

PostPosted: Fri Dec 08, 2006 11:06 pm
by Forbesy
:shock: OMG that is unbelievable! cannot believe they did that lol!

PostPosted: Tue Dec 26, 2006 2:31 am
by sleepincivic
1993 Civic Si wrote:Check this for the ultimate in weight reduction...

http://crazyjim.ramelot.com/14seconds.htm

8)


man thats insane...

PostPosted: Thu Dec 28, 2006 9:42 pm
by obedd15
Thats always good for a laugh. Good luck on the diet.

PostPosted: Mon Mar 26, 2007 6:35 am
by boxcarracer0260
Forbesy wrote::shock: OMG that is unbelievable! cannot believe they did that lol!

i would have to agree

PostPosted: Wed Mar 28, 2007 11:10 pm
by civicnation93
Holy shit! >< I wonder who paid for the ... "damages" done to the car!? Lol...not bad tho...

We find three kittens and a squirrel cowering in fear inside one of the massive front air intakes.

PostPosted: Wed Mar 28, 2007 11:21 pm
by ChicagoMike
Since this is on weight, I'll show some progress on my car.

Image

I do plan on wire tucking the back some time soon!!!
Image

Image

PostPosted: Wed Mar 28, 2007 11:41 pm
by EGcivic
Kind of depends how far you want to go really.
If you don't need to ever put the rear seats in again then you can remove all the metal brackets that hold them in, and the rear trim brackets.

Image

That pic was taken part way though before I took out the remaining bracket & jack mount too.

You can also take some weight out of the doors too.

Image

Again this pic was taken before more/bigger holes were made.

And underneath the car the rear end has loads of metal that really isn't needed down by the rear arches.

Image

If you want to be really picky (like me) you can smooth out all the casting marks on the front hubs/suspension and cut off all the excess metal that protrude from all torqued down suspension & engine bolts!!! Every little helps!!! :D