Civic EG

So if im right your saying why a EK and not a ITR because i got this for 10.00
rather than 100 plus for ITR. If i can get my hands on a JDM EK sir one that will be smokin
Any Ways OK what youll need
EK cluster with plugs and as much wire as you can get from the harness
wire strippers
soldering iron
elec tape
wire loom if you want
wiring diagram found mine on honda tech
dremel tool for cutting and sanding
Epoxy quick set
zap straps
this is the wiring diagram

this is after i have cut the top plastic off

see how thin it is once all the plastics are shaved off

i had to knotch the bezel so the eg cover would fit

here is the eg bezel after i shaved and hollowed it out so it was able to sit flush with the ek bezel

this is the reverse side

had to knotch out a lil bit because of a raised part on the ek bezel

here is the raised part

here is the eg bezel once i finished moding it

here on the bottom corner the is a lil nub had to shave it down flush

here is the eg mounted on the ek bezel notice i modded the odo button cause i didnt line up properly so i made a new one using the rod from my eg cluster

heres the cover on

see how it sit nice and flush

I drilled holes into the eg front and fed zap straps through to attach the cluster to it

here where it attaches to on the cluster

here are the stages of wiring once the wires were matched up and soldered together see there is one thats not hooked up thats the low fuel light egs dont have that

here are the plugs separated and taped you could stop here if you want
then hook it all up

here i used wire loom to clean it up

and TAHDAH !!!!

see if you can mod the eg bezel you can use the mounting holes and then you dont have to jimmy rig brackets
i still have to glue the clear case back on the bezel and repaint the bezel
but there you have it took me 2 days to do all that with interuptions from my 3 yr old son hes daddies lil helper