Civic EG

Hey guys, i'm finally getting around to rebuilding this b16 sitting in my garage and putting it into my 271k stock 4 door :-D

I have a couple of questions, after doing some reading will I need to change out my hubs when switching the axles to the integra axles?

Also, how do I figure out what year the motor is so I can make sure I get the right axles and ecu.

if the motor has no wire harness you can tell if there is a knock sensor on it and no oil sensor on v-tec solinode it is 96 and up, but it really does not mater you will need to run a p30 or chipped p28 to run it and b searis axles fit any b searis box ..

You don't change out the hubs.

Thanks for the answers guys, did a lot of research the past couple of days and the new motor should be built and in the car in a month or so. Thanks again!