- Sun Apr 08, 2012 12:38 am
#301218
hey guys i have a b20b which i recently put an obdo b16 head on. went to get a base map / tuned and v tec isnt working. i get to 5200 and it falls flat on its face. boggs soo hard that its like i slam the clutch in, dropps rpm, after a second or so its like i dump the clutch and it starts driving again. at this point i let off the gas and get frustrated. i have tried everything. the sel works, when given power it clicks. i tried another sel just in case. tried another comp too. even wired the v tec straight to the comp board to make sure i was getting connection.
what can you guys rec i check? this is all very frustrating
what can you guys rec i check? this is all very frustrating