b20 swap into hatch problem

B16, B18, B20
 Reply

By bks84
- Wed Nov 30, 2011 8:58 pm #283518 visually inspect the o2, maybe a wire has popped out.

By blueg
- Thu Dec 01, 2011 12:49 am #283548 i replaced the o2 sensor and got rid of that code and took it out for a drive up the road now on my way back i got the cel and got codes 43 and 7 now i know 7 is the tps and 43 is fuel supply system now its low on gas could that be the cause of the 43
now if it matters at all it idles fine but as soon as i press the gas it bogs immediatly

By blueg
- Thu Dec 01, 2011 5:08 pm #283646 i have gotten rid of the fuel supply code i guess it was to low on gas but no gas light came on so now im stuck with 7 again why would it flash 7 after i just replaced it ??

By bks84
- Thu Dec 01, 2011 8:19 pm #283665 is the sensor NEW? then you more than likely have a bad sensor or its not calibrated correctly.

By blueg
- Fri Dec 02, 2011 5:20 am #283724 no its not new it came from a donor car i got the whole intake manny and tb and just used the whole tb off it and it was off for a little while and then came back up

im just thinking that it would have come up right away if it was calibrated wrong wouldnt it ?

By blueg
- Mon Dec 05, 2011 11:10 pm #284264 finally all fixed except for a lumpy idle now no codes nothing and runs good for now except for the idle thanks for the help guys !!!
 Reply
Return to B Series