Page 1 of 2

B20 Vtec Turbo - Running lean after warm up? Why?

PostPosted: Sat Aug 06, 2011 5:06 am
by B20vtec-turbo
As titled say's, my engine is running lean after it warms up. It's driving me crazy and I'm having trouble locating the problem. Anyone have any idea's??

I can Start the car and it starts perfect, Idles perfect, AF read's perfect, until about the temp 170-177, then it starts to idle alittle rough and AF's jump back and forth from 16 through --, why is this? I haven't driven the car because I'm scared of messing something up running it lean like that, so I don't know AF at WOT. I know when it's idling lean, I can give it gas and the fuel comes back and AF reads fine, once the rpm's come back down, straight back to lean....wth?

EDIT... I'm running the hondata s300 and the only tune I have is one a tuner gave me that was a dyno tune for a engine like mine, expect different size injector's. So if one of you know's alot about the Smanager, is there a place in there that I can up the fuel on idle after warm up??
Post thought's below....

PostPosted: Sat Aug 06, 2011 7:02 am
by RWMIII
sounds like a possible exhaust leak or vacuum leak.

PostPosted: Sat Aug 06, 2011 7:14 pm
by B20vtec-turbo
Added more info to original post ^^^

PostPosted: Sat Aug 06, 2011 8:10 pm
by RWMIII
under the idle parameter, what are your values for all areas?

PostPosted: Sat Aug 06, 2011 8:15 pm
by B20vtec-turbo
Image

PostPosted: Sat Aug 06, 2011 8:17 pm
by RWMIII
edit: nvm. link was jacked up

PostPosted: Sat Aug 06, 2011 8:19 pm
by B20vtec-turbo
edited

PostPosted: Sat Aug 06, 2011 8:34 pm
by B20vtec-turbo
any idea's?

Re: B20 Vtec Turbo - Running lean after warm up? Why?

PostPosted: Sat Aug 06, 2011 8:56 pm
by RWMIII
B20vtec-turbo wrote:EDIT... I'm running the hondata s300 and the only tune I have is one a tuner gave me that was a dyno tune for a engine like mine, expect different size injector's. So if one of you know's alot about the Smanager, is there a place in there that I can up the fuel on idle after warm up??
Post thought's below....



just saw your edit

under your fuel com parameter you can adjust your air/water temp comps for fuel. what does your closed-loop low load look like? I have always set these to 0 across the board. And on open-loop low load after 175 degrees I go with no correction as well. (under water temp comps)

PostPosted: Sat Aug 06, 2011 10:30 pm
by B20vtec-turbo
Image


Image

PostPosted: Sat Aug 06, 2011 11:50 pm
by RWMIII
can you run a datalog with it acting up? i dont care for some of the entered value ranges, but would like to see what things are looking like when it starts to go lean. ill pm you my email address.

PostPosted: Sat Aug 06, 2011 11:58 pm
by b20_link
if u run lean all the time u going to fuck something up like
turbo
piston
valve
or warped your head

PostPosted: Sun Aug 07, 2011 7:22 am
by B20vtec-turbo
RWMIII wrote:can you run a datalog with it acting up? i dont care for some of the entered value ranges, but would like to see what things are looking like when it starts to go lean. ill pm you my email address.


I just emailed you the tune I'm running and also a data log after warm up, going lean at idle...

EDIT - I just went over the data long, dude look at my AF, it starts out low and you can see it slowing going up...wth?

Image

PostPosted: Sun Aug 07, 2011 7:28 am
by B20vtec-turbo
b20_link wrote:if u run lean all the time u going to fuck something up like
turbo
piston
valve
or warped your head


I know man, thats why I haven't drove the car... I'm trying to figure out whats wrong so I can fix it.

PostPosted: Sun Aug 07, 2011 11:20 am
by RWMIII
got it. im going to go over it when i get to work.