Civic EG

Posted: **Mon Oct 04, 2010 11:35 am**

i have a 92 civic hatch with a b16a obd1. Needed a axle so i went to autozone and pick up a em1 axle. so here is the problem:

where it hooks up to the halfshaft it is not tight on there, so when i give it gas it shakes. What axles should i try?? i already tryed 2 em1 autozone axles!!!

Posted: **Thu Oct 07, 2010 8:25 pm**

Slap on GSR axles..
should be a perfect fit..

EG+DC share the same chassis plus many interchangeable parts..

EG+EK(EM1) Dont really mix.. lol.

Posted: **Thu Oct 07, 2010 8:58 pm**

^^ I agree i always bought axles for a 95 Integra GSR and never had issues. we did this with a B18 & B16 swap

Posted: **Fri Oct 08, 2010 2:31 am**

I'm Running Em1 b16 axles in my b20/b16 tranny delsol and have no issues. However the only reason I have them is the swap use to be in an EK hatch.

Posted: **Fri Oct 08, 2010 3:15 am**

DC/EK axles are the same. Ive got a mix of them on mine as it is.

Make sure you have the axle seated all the way.

Posted: **Fri Oct 08, 2010 11:44 am**

thanks for the replies!! ill try 95 integra gsr!! i tryed 2 em1 axles from auto zone and made sure it clicked into position on the half-shaft!! Both wobbled at the half shaft!!

Posted: **Fri Oct 08, 2010 6:03 pm**

check and make sure the halfshaft is still good.

Posted: **Fri Oct 08, 2010 6:19 pm**

what can i do to check the half-shaft? i mean it looks ok

Posted: **Fri Oct 08, 2010 6:36 pm**

the axles shouldnt wobble in it. they should fit tight.

Posted: **Fri Oct 08, 2010 7:26 pm**

the axles that came with the swap were original to the motor, it fits in the half shaft perfect but its just those autozone em1 axles didnt fit tight

Posted: **Fri Oct 08, 2010 8:10 pm**

get an ebay set.. =] or advanced auto.. pep boys..

Civic EG

b16a axles!!!!!

b16a axles!!!!!