Civic EG

Well my roommate has a 92 Acura integra. An my prob is that when Im taking it through its gears it kinda bogs out an stops accelerating around 3 thousand then kicks back around four. My question is, why is that an how can i fix it? A little info on the motor, its a b18a1 An is completly rebuilt for turbo. But still n/a for now. Any help will be great. Thanks

is the ecu throwing any check codes?

have you double check the ecu wring connections? or like metioned above, does it flash the CEL?

assuming that the car hasnt really been modded or torn apart make sure that the light actually works. some people pull the bulb to make you think its not on.

so key over the ignition and see if it pops on for a second. if not theres prolly a cel.

get a bulb and stick it in there then i beleive its by the ecu where you car use a paper clip to jump the connection and the check light will blink your code.

since its obd1 you cant just look at the little blinky light like obd0

No codes. Thats another reason im asking.
An its obd0.

Negative. It's Obd1

92-95 teggys are obd1
could be it needs a tune up?

This car is a early 92 an its a obd0. To prove it, the ecu has the light in it. I just dont know why it would do that an throw no codes.

ahhh i see i appologize for my mistake

and id give it some plugs and wires dist. cap and rotor. see if that helps

get some pics of the bay, and what ecu is on the car?

I have no idea what ecu it is. Its all stock. Im not going to be able to get a pic of the the bay for awhile. My roommate took off out of state. Any suggestions of what i should check out when he gets back?