Civic EG

i wanna kno where i can find any ctr or itr stuff like pistons rods etc.

check here

http://yhst-1408381693991.stores.yahoo.net/

hope this helps

http://www.fjdistributors.com <- look under all motor or naturally aspriated

http://hmotorsonline.com/shop/sc2000sea ... ne%20Parts <- few pages to sift threw

thanks guys ill look at it all cuz i wanna do a poormans type r

http://hmotorsonline.com/shop/sc2000sea ... item=10002

169 OMFG

so these r the pistons i should use then

the ctr pistons will put your compression up there pretty good, a poor mans R will run great, i love mine and its still all stock gsr stuff in the bottom end... before you buy pistons you just need to figure out exactly what you want to do and what your goals are, you cant blindly buy parts for a build your not 100% sure on your goal

yea thats true i think i would wanna either go completely stock or a stock bottom end wit a built head

i would recomend either the jdm or usdm itr pistons then.... they wont give you too much compression...

ok kool im still figuring out wat im gonna do but is urs completely stock

yes sir, mine is a bone stock usdm gsr bottom end 95 spec, with a 2000 si head, mild port job, i had the valves re-surfaced, i used the gsr cams, and arp head studs, and everything else is stock, intake manifold, throttle body, injectors, everythings stock... when i had that engine in the car i have the turbo on now, i had that enigne, with a dc ITR replica header ande a stg 2 clutch and a gsr trans, it ran very good and pulled very hard, i out ran a dyno tuned z6 on like 9psi, i also had my chipped p28 behind it then,

now i have it in my dd with a stock clutch, LS grears and a gsr ecu and a 4to2to1 header.... but it still runs great...

hell yea i wouldnt wanna go turbo yet i will wait a while before that

a friend of mine has a turbo poormans r in his crx, and it runs really good, i never turbo'd mine tho, i decided to turbo a b16 instea lol... my poormans is getting miles on it now, so id like to freshin it up an maybe do a high compression kit... but all in all a poormans r is a solid setup imo

thats wat i keep hearing and thats y i wanna do it