arp head studs
Posted:
Sun Apr 11, 2010 5:01 pmby Benj
ok so today i got my arp head studs in and as im looking at them i notice that 2 are about an inch longer... why and where do these go? the motor is a b18a1 with pr4 head. any help would be great.. oh and kit number is 2084302... lmk thxz
Ben
Posted:
Sun Apr 11, 2010 5:16 pmby Ajax1989
i believe they go in the top corners of the head, not 100% sure tho
Posted:
Sun Apr 11, 2010 7:37 pmby That One Dude
When you go to pull off the head, pay attention to which bolts are longer. Problem solved.
Posted:
Sun Apr 11, 2010 9:38 pmby Benj
That One Dude wrote:When you go to pull off the head, pay attention to which bolts are longer. Problem solved.
it would help if i didnt do a tare down almost 3 years ago
Posted:
Sun Apr 11, 2010 9:52 pmby That One Dude
Oohh....good call. The two longer bolts go in the center holes from what I can tell. The corners are the shorter studs, I know that for a fact.
Since it's already torn down, I'd say just set the head on the block with no gasket, and simply thread down the studs by hand to see which ones go where.
Posted:
Sun Apr 11, 2010 10:21 pmby Benj
That One Dude wrote:Since it's already torn down, I'd say just set the head on the block with no gasket, and simply thread down the studs by hand to see which ones go where.
Yah that's what I think I'm gonna do
Posted:
Mon Apr 12, 2010 12:30 pmby forcefedEG
the long ones are the 2 center ones on a LS... the longest ones go in the center and the rest dont mattter