Civic EG

I have a stock b16a and I'm thinking about boring it out, what would someone with expirience say??? And also what small mods are there to get some more horse power out of my b16a that I'm building from the short block???

i wouldnt advise boring past .040 on stock liners, i would believe they would become too thin after that poin imo.... i only like goin or .020 or .030... the least you can go to clean up the cylinder the better off you are, dont bore to the max unless you have to.... you wont see a major diference in just a little bit of an over size bore.... hope that helps