Page 1 of 1
question about boosting the f22
Posted:
Thu Aug 08, 2013 4:34 pm
by wolfman93
Is there any way to boost a high compression built f22? Im talking h23 rods and h22a4 pistons. according to zealautowerks.com its like 11.4:1 compression. But I want to put 10-15 psi to it and put down close to 400 hp. Am I out of my mind or is this possible?
Posted:
Thu Aug 08, 2013 7:51 pm
by JUICE
CR should be ok, but cast pistons are prone to melting above 300whp on pump gas and 400whp-ish on ethanol. Good tuner is a must either way.
Posted:
Thu Aug 08, 2013 9:46 pm
by Uknterror
Did you even check too see what your piston to deck height was? Remember a negative number means the piston is above the block
Posted:
Wed Aug 28, 2013 3:56 pm
by wolfman93
Decided to scratch the f22. F20B is the way Im going. Its gonna stay all motor for now and boosted later on.
Posted:
Wed Aug 28, 2013 4:13 pm
by HeikDiesel
Any reason why you want the f20 compared to the h23 vtec?
Posted:
Wed Aug 28, 2013 4:18 pm
by wolfman93
It has iron sleeves instead of the frm ones that the h series has. And a friend of mine has the swap that I can get really cheap just cuz he went different route.
Posted:
Wed Aug 28, 2013 4:23 pm
by wolfman93
And he has all of the parts Ill need to put it in my hatch.
Posted:
Thu Aug 29, 2013 2:05 am
by Uknterror
Sounds good!