Page 1 of 1

Crank no start, ignition rotor not moving.

PostPosted: Sat Sep 17, 2016 9:47 pm
by 92civeg
Hey guys!

My 92 1.5 wont start, it just cranks.

I replaced the plugs, wires, and cap. no luck

I noticed that when cranking the rotor doesnt move. I was thinking bad coil... Thoughts?

I need this car to run, any info would be great.

Re: Crank no start, ignition rotor not moving.

PostPosted: Sun Sep 18, 2016 1:57 pm
by TrailerTrash
sounds like the timing belt. pop the cover off and see if it is still intact

Re: Crank no start, ignition rotor not moving.

PostPosted: Mon Sep 19, 2016 2:11 pm
by Driv-it-hard
Timing belt or broken shaft on the Dizzy. Take of the cap on the dizzy and make sure you can spin the rotor button. If you can , that is your prob. Also check your timing belt.