D15, D16, D17 and Mini-Me swaps
By doubleV
#357847 good day guys, i was thinking of swapping some parts for my motor.
its a d15b bottom, and non vtec head with single carb.
question is what do i need to do to make it pgmfi?

i was thinking to swap these parts.
take the carb manifold and replace it with the injected one
change distributor
change fuel tank to injected one
wiring harness

or it would be easy or cheaper to swap the whole head to po8 ones, then do the wiring and change the fuel tanks and fuel lines

if there is any write up or could point me in the right direction you could share please do so and it will be much appreciated.

i know there might be a write up somewhere but been looking for days about it and could get a hold of one.

Thank in advance