D15, D16, D17 and Mini-Me swaps
By Wisconsintailtaggers
#354975 I got the car to run now. But now it has no power. Car is really sluggish hen takes off. I have two codes. One for an O2 sensor and the other is for automatic transmission lock up valve. Car is manual?! I have replaced the fuel filter and the plugs. They were really nasty becusse the plug tube seals were junk. So I replaced the vc gasket too.
User avatar
By EconoBox
#354989 Open you ECU and follow this write up to get rid of the Automatic code.
http://honda-tech.com/tech-misc-15/diy-how-convert-obd1-automatic-ecu-manual-2969571/

For the o2 sensor double check that its plugged in and none of the wiring is damaged. If that looks good replace it with a new one.
By Wisconsintailtaggers
#355008
EconoBox wrote:Open you ECU and follow this write up to get rid of the Automatic code.
http://honda-tech.com/tech-misc-15/diy-how-convert-obd1-automatic-ecu-manual-2969571/

For the o2 sensor double check that its plugged in and none of the wiring is damaged. If that looks good replace it with a new one.


It's running a p06 ecu which is a manual ecu right? The plug is gone on O2 sensor. The wires all still have ends they are just pushed into the connector. Junk.