Civic EG

Been awhile since I am on here.. but it feels good to be back on here.

Long story short, dad got my uncle's 92 VX and I am in the mist of tuning her up before smog check.

So when the car turned over, I see oil bubbles around the Valve timing oil pressure unit. It should be the gasket needs replacement, but what information I need to worry about or just unbolt the (2) screw and replace it?

Any info helps and thank you.

valve timing oil pressure unit? can you post a picture

err. Can't upload picture from phone... But it is this one


http://www.hondaautomotiveparts.com/aut ... AD+%282%29

looking at number #10, but the oil is bubbling out on #15. I think this is the vtec solenoid... Never had a vtec to work on, so this will be the first.

Ok so basically there is two pieces to that. The solenoid on the top and the valve body on the bottom. Just get #13, and #15. It's super simple to re-seal that, and you might as well put a new screen in while you're in there.

Thank you!!!! Will do, ordering up all the parts for the major tune up.

New screen? Is there a screen around that area or part?