- Fri May 11, 2012 6:00 am
#304596
first question/concern...SOMETIMES not always..when i try to start the car it wont start...it cranks over but just wont fire up...probebly something to do with spark or fuel...but i was wondering if this has happend to anyone before after doing this swap??
second..once again sometimes but not always..at idle it will rev up and down a little for a second and be ok..then do it again...mostly when i first start the car...and it does it makes no dif. if the car is cold or warm..does it at both times...??
and third....i went to wire up my vtec today and put the pins in my factory wire harness...but the A4 and D6 pins already had wires in them??...i didnt have time tonight to trace them and see where they end up..but i figured id ask about it any way...also my car is an LX sedan...i know the hatchs have them pre-wired up to the strut tower...but i thought my car doesnt have it pre wired?
any suggestions or help would be greatly appriciated
thanks in advance
second..once again sometimes but not always..at idle it will rev up and down a little for a second and be ok..then do it again...mostly when i first start the car...and it does it makes no dif. if the car is cold or warm..does it at both times...??
and third....i went to wire up my vtec today and put the pins in my factory wire harness...but the A4 and D6 pins already had wires in them??...i didnt have time tonight to trace them and see where they end up..but i figured id ask about it any way...also my car is an LX sedan...i know the hatchs have them pre-wired up to the strut tower...but i thought my car doesnt have it pre wired?
any suggestions or help would be greatly appriciated
thanks in advance
EG8 Build: http://civic-eg.com/viewtopic.php?t=20985&highlight=
EK Build: http://civic-eg.com/viewtopic.php?t=257 ... highlight= SOLD
#10 of The Civic-EG.com Ferio Squad
EK Build: http://civic-eg.com/viewtopic.php?t=257 ... highlight= SOLD
#10 of The Civic-EG.com Ferio Squad