3stage vtec in an eg8

D15, D16, D17 and Mini-Me swaps
 Reply

3stage vtec in an eg8

By anya2dgre
- Tue Jan 24, 2012 4:43 am #291671 Can any one tell me what this green jack is for. The harness is for the p2j-j62 ek vtec manual transmission
Image

3 stage vtec engine in an eg8

By anya2dgre
- Thu Feb 02, 2012 5:12 am #292979 After doing some research in an ek3 repair/service manual (1996-2000) it is stated that this connector goes to the main harness. Is any one familiar with the under dash electrical of an eg8. If so does the eg8 have any connector similar to this one that connects to the main harness as explained.
User avatar

By teal_dx
- Thu Feb 02, 2012 2:36 pm #293018 Are you attempting to run the OBD2 3-stage vtec motor in an OBD1 car? CVT or manual transmission?

I'm wondering if you will have to switch the entire under dash/cabin harness now?

3stage vtec in an eg8

By anya2dgre
- Mon Feb 06, 2012 4:00 am #293466 Its manual transmission. I am using back my s20 gear box. I might have to wire it into the obd1 under dash harness. Still doing research on the wiring color codes. I'll have to post some pics.

3stage vtec in an eg8

By anya2dgre
- Thu Feb 16, 2012 12:30 am #295127 Presently I am labeling up my obd2 harness making sure I have no missing sensors etc. Its a little hard cause its my first time but in the end it will pay off I believe.

By anya2dgre
- Thu Aug 29, 2013 4:22 am #336086 Image This is the obd2 3 stage vtec. I did manage to wire it in the under dash with out removing the harness.
Last edited by anya2dgre on Thu Aug 29, 2013 4:33 am, edited 1 time in total.

By ktang
- Thu Aug 29, 2013 6:03 am #336089 Wild guess: on my EG, the green connector goes to my climate control module.
 Reply
Return to D Series