Civic EG

My D13 ;)

here is my D16Z6

parts list/machine work is as follows

-head was milled and valves where newly seated and has new seals
-NGK spark plugs and wires
-Spec-D tuning 4-2-1 header
-short ream intake with K&N filter
-Y8 intake manifold
-stage 3 XTD 6 puck sprung clutch
-P28 chipped ecu

-brand new crank with matching bearings and rod replacement $400
-OEM oil pump from Honda $140
-OEM water pump from Honda $65
-OEM timing belt from Honda $40
-Hastings piston rings (std. bore) $35
-honed out cylinders (did my self)
-new oil pan $75
-ARP head studs $110
-ALL the seals and gaskets in the lower end (head gasket, rear main seal, oil pan gasket etc. etc.) all about $75

so basically the bottom end is brand new

i have put about 500 miles on it so far and everything seems to be running awesome..the car started right up with out any hesitation on its first start up...it sounds like its running really healthy so far

i painted the block and transmission to make them look nice as well


Untitled by Busone10, on Flickr


Untitled by Busone10, on Flickr


Untitled by Busone10, on Flickr


Untitled by Busone10, on Flickr


Untitled by Busone10, on Flickr


Untitled by Busone10, on Flickr

ARP head studs installed

Untitled by Busone10, on Flickr

just about to put it all back in the car

Untitled by Busone10, on Flickr

sorry for some of the blurry pics but this is it all in the car

Untitled by Busone10, on Flickr

sickvtec wrote:does anybody runs a single carburetor? please post your picture here if ya dont mind

My ride runs on carb. I'll post some pics later

junmadrid wrote:

sickvtec wrote:does anybody runs a single carburetor? please post your picture here if ya dont mind

My ride runs on carb. I'll post some pics later

looking forward to seeing it!!

1-low-92-EG-Sedan wrote:

junmadrid wrote:

sickvtec wrote:does anybody runs a single carburetor? please post your picture here if ya dont mind

My ride runs on carb. I'll post some pics later

looking forward to seeing it!!

Here is my D-series running on carbs

102hp of slow fury

thats my on carb:



and after on carbs:

I have been wanting to do a carb-efi swap. If ever I'll be doing this, I'll also be doing an engine swap to vtec as well. Surplus JDM vtec engines sold here in the Philippines already comes complete with fuel injection.

Kind of plain but I've got some goodies comin ;)

imma post a link to my semi wire tuck d15b vtec engine bay. painted by myself

My fresh rebuilt z6

My D15B7!

my z6