Discussion of the use of Nitrous on all motors
By Bh3417
#265623 it's a ls vtec bored 20 over eagle knife edge crank eagle rods 10:1 b16 head with mild port jg valves springs and retainer factory b16a cams at the moment aftermarket throttle body and blox intake with Hondata
And what else will I need to run it
User avatar
By TrailerTrash
#265661 a nitrous setup and a good tune
User avatar
By chrono404
#265663 You have what sounds like a built bottom end. Go for as big of a shot as you want. Rule of thumb when it comes to nitrous is to not go over power wise what your weakest component will fail at. Such as in D16's going over 250 hp on a stock block is a bad idea as thats where the Rods are no longer reliable.

Get a Wet Nitrous kit for a Chevy V8 off ebay, they are cheap. They will start off with 75hp, 150hp and 300hp jets. start off with 75shot gets and tune it in. We have a thread in the nitrous section on how to do so. If you want more you can swap out to a bigger jet.

Also when calculating fuel jets or getting ready to "massage" your jets with a dremel to make a bigger shot. Use Robby the robots nitrous calculator to figure out what jet sizes you need.

In the nitrous thread it links to the Honda-Tech nitrous thread. before installing it look over everything they have in it and absorb that information. Once tuned correctly nitrous is awesome. make the person in the other lane afraid. :lol: :thumb:
User avatar
By Eg6H2D
#265688
chrono404 wrote:You have what sounds like a built bottom end. Go for as big of a shot as you want. Rule of thumb when it comes to nitrous is to not go over power wise what your weakest component will fail at. Such as in D16's going over 250 hp on a stock block is a bad idea as thats where the Rods are no longer reliable.

Get a Wet Nitrous kit for a Chevy V8 off ebay, they are cheap. They will start off with 75hp, 150hp and 300hp jets. start off with 75shot gets and tune it in. We have a thread in the nitrous section on how to do so. If you want more you can swap out to a bigger jet.

Also when calculating fuel jets or getting ready to "massage" your jets with a dremel to make a bigger shot. Use Robby the robots nitrous calculator to figure out what jet sizes you need.

In the nitrous thread it links to the Honda-Tech nitrous thread. before installing it look over everything they have in it and absorb that information. Once tuned correctly nitrous is awesome. make the person in the other lane afraid. :lol: :thumb:


^^ :thumb: